Microtopping Finishes in Dubai Marina

Yes, mostly. Both terms describe a thin (typically 2–4 mm) hand-trowelled polymer-modified cementitious overlay. Different manufacturers use different names for what is essentially the same system family.

Yes — that's one of the main reasons clients choose microtopping. We bond-test the existing tile, key the surface, prime, and apply the system directly. No demolition, no dust event.

≈ 3 mm of microcement + the sealer film. The build-up bridges hairline movement in the substrate via an embedded fibreglass mesh.

Only if the substrate moves. We embed fibreglass mesh in the first base coat to bridge minor hairline movement. For structural cracks, we crack-stitch the substrate first.

Once cured and sealed, microtopping is dimensionally stable in UAE humidity. We use a UV-stable PU sealer specifically chosen against yellowing under direct sun.

Water-resistant by default. Fully waterproof on request — we apply an additional waterproofing membrane (e.g. Mapei Mapelastic Aquadefense) beneath the microcement for wet rooms.

On floors, the sealer is the wear surface — it can be re-coated every 5–7 years without re-doing the microcement. On walls, the system effectively lasts as long as the substrate.

Yes. We produce mock-up samples on a 30 × 30 cm board before site mobilisation. Custom matches against fabric, stone or paint references are routine.

A typical bathroom: 4–6 working days end to end. A villa living area: 7–10 working days. The schedule is driven by cure times between coats, not labour.

AED 320–420 / m² depending on area, finish complexity, sealer choice and access. Mock-up samples and method statement are produced before commitment.